#DENOISER III TURNS BLACK FOR MAC#
#DENOISER III TURNS BLACK MANUAL#

Either way, this 'raw' 10.2V gets regulated down to 5V by a Burr-Brown REG103FA - arguably 'fancy'.

The naughty part of that is that i'm measuring about +/-10.2V on the analog supplies, and good engineering practice is to leave at least a 20% voltage margin for a capacitor rating, versus the voltage expected across it, NOT to use them right at their rated limits, or even slightly above.This then gets further knocked down by a National Semiconductor LM1117-3.3, to feed the processors.Speaking of electrolytics, the black ones are Meritek(?), while the blue ones are Lelon. Tisk-tisk-tisk.There's one other bridge rectifier being fed by the analog-supply transformer, but this one has an 0.47 ohm resistor hanging off its '+' output, and a 180 ohm one off its '-' output. The former goes off to the 8-pin header for the front panel. The latter though, feeds an MC7906 negative voltage regulator putting out -6V.

#DENOISER III TURNS BLACK FOR MAC#

Jack compatibilitењњonnects via pci | allows use of pro tools LE 5.x on mac os 9.xAlso allows use of up to pro tools 6.4 on osx pantherCompatibility ranges from os9 - osx 10.3 | also works with windows xp on x86 systemsSteinberg wrote a special asio driver for using this with cubase vst: (scroll to bottom)Connects via firewire | allows use of pro tools LE 5.x on mac os 9.xDrivers range from win98-windowsXP for pc | os9-osx for mac (not sure how high osx version it will go to, most likely tiger ppc, but MAY work for leopard PPC. Either way, off comes the top, and we're greeted with a.

'suitably' (relatively) old-school design. Not one, not two, but three(!) transformers in the power supply. These give the unit quite a bit of heft, albeit slightly right-side-heavy. (not included on original version)With a forum a pci card.

#DENOISER III TURNS BLACK MANUAL#

The manual was easy to read through and understand.Connects via firewire | mkII has added features: MIDI I/O, word clock support and SMPTE sync. The MOTU 828MK3 is a firewire or a USB connected interface. The 828mkII provides the following simultaneous, independent inputs and outputs: 8 channels of quarter-inch TRS 24-bit 96kHz analog I/O (with individually switchable +4/-10 reference levels on input), 2 mic inputs with preamps and phantom power, 8 channels of 24-bit ADAT optical digital I/O (4 channels at 96kHz), 24-bit 96kHz.

Denoiser iii turns black